| # Board |
| CONFIG_VENDOR_GOOGLE=y |
| CONFIG_BOARD_GOOGLE_DELTAN=y |
| CONFIG_CHROMEOS=y |
| |
| # Other dependencies |
| CONFIG_PAYLOAD_NONE=y |
| CONFIG_USE_BLOBS=y |
| |
| # SPI Flash Descriptor |
| CONFIG_HAVE_IFD_BIN=y |
| CONFIG_IFD_BIN_PATH="3rdparty/blobs/baseboard/deltaur/descriptor-deltan.bin" |
| |
| # FSP Blobs |
| CONFIG_ADD_FSP_BINARIES=y |
| CONFIG_HAVE_INTEL_FSP_REPO=y |
| # CONFIG_FSP_USE_REPO is not set |
| CONFIG_FSP_M_FILE="3rdparty/blobs/intel/tgl/fsp/fspm.bin" |
| CONFIG_FSP_S_FILE="3rdparty/blobs/intel/tgl/fsp/fsps.bin" |
| CONFIG_FSP_M_XIP=y |
| CONFIG_RUN_FSP_GOP=y |
| |
| # Management Engine |
| CONFIG_HAVE_ME_BIN=y |
| CONFIG_ME_BIN_PATH="3rdparty/blobs/baseboard/deltaur/csme-deltan.bin" |
| |
| # EC |
| CONFIG_HAVE_EC_BIN=y |
| CONFIG_EC_BIN_PATH="3rdparty/blobs/baseboard/deltaur/ec-deltan.bin" |
| |
| # Microcode |
| CONFIG_CPU_UCODE_BINARIES="3rdparty/blobs/baseboard/deltaur/ucode.bin" |
| CONFIG_CPU_MICROCODE_CBFS_EXTERNAL_BINS=y |
| |
| # Video BIOS Table |
| CONFIG_INTEL_GMA_ADD_VBT=y |
| CONFIG_INTEL_GMA_VBT_FILE="3rdparty/blobs/baseboard/deltaur/vbt.bin" |
| |
| # GbE firmware |
| CONFIG_HAVE_GBE_BIN=y |
| CONFIG_GBE_BIN_PATH="3rdparty/blobs/baseboard/deltaur/gbe.bin" |
| |
| # Serial console disabled by default (do not remove) |
| # CONFIG_CONSOLE_SERIAL is not set |
| |
| # Event Logging |
| CONFIG_CMOS_POST=y |
| CONFIG_CMOS_POST_OFFSET=0x70 |
| CONFIG_CMOS_POST_EXTRA=y |
| CONFIG_ELOG_GSMI=y |
| CONFIG_ELOG_BOOT_COUNT=y |
| CONFIG_ELOG_BOOT_COUNT_CMOS_OFFSET=144 |
| |
| # SPI flash support in SMM |
| CONFIG_SPI_FLASH_SMM=y |
| |
| # For bringup, we don't want to enable EC software sync just yet. |
| CONFIG_GBB_FLAG_DISABLE_EC_SOFTWARE_SYNC=y |
| |
| # Wilco specific |
| CONFIG_HDA_CODEC_ID=0x8B8 |
| |
| # Mainboard needs to be stay off after power failure to have consistent |
| # results from the power state machine in the embedded controller. |
| CONFIG_POWER_STATE_OFF_AFTER_FAILURE=y |
| |
| # Do not modify descriptor region access to ensure that the settings |
| # applied in the FIT tool will persist. In particular the EC region |
| # should not be writable in order to prevent flashrom issues. |
| CONFIG_DO_NOT_TOUCH_DESCRIPTOR_REGION=y |
