| /* SPDX-License-Identifier: GPL-2.0-or-later */ | |
| /* | |
| * gpio-regulator.h | |
| * | |
| * Copyright 2011 Heiko Stuebner <heiko@sntech.de> | |
| * | |
| * based on fixed.h | |
| * | |
| * Copyright 2008 Wolfson Microelectronics PLC. | |
| * | |
| * Author: Mark Brown <broonie@opensource.wolfsonmicro.com> | |
| * | |
| * Copyright (c) 2009 Nokia Corporation | |
| * Roger Quadros <ext-roger.quadros@nokia.com> | |
| */ | |
| #ifndef __REGULATOR_GPIO_H | |
| #define __REGULATOR_GPIO_H | |
| #include <linux/gpio/consumer.h> | |
| struct regulator_init_data; | |
| enum regulator_type; | |
| /** | |
| * struct gpio_regulator_state - state description | |
| * @value: microvolts or microamps | |
| * @gpios: bitfield of gpio target-states for the value | |
| * | |
| * This structure describes a supported setting of the regulator | |
| * and the necessary gpio-state to achieve it. | |
| * | |
| * The n-th bit in the bitfield describes the state of the n-th GPIO | |
| * from the gpios-array defined in gpio_regulator_config below. | |
| */ | |
| struct gpio_regulator_state { | |
| int value; | |
| int gpios; | |
| }; | |
| /** | |
| * struct gpio_regulator_config - config structure | |
| * @supply_name: Name of the regulator supply | |
| * @input_supply: Name of the input regulator supply | |
| * @enabled_at_boot: Whether regulator has been enabled at | |
| * boot or not. 1 = Yes, 0 = No | |
| * This is used to keep the regulator at | |
| * the default state | |
| * @startup_delay: Start-up time in microseconds | |
| * @gflags: Array of GPIO configuration flags for initial | |
| * states | |
| * @ngpios: Number of GPIOs and configurations available | |
| * @states: Array of gpio_regulator_state entries describing | |
| * the gpio state for specific voltages | |
| * @nr_states: Number of states available | |
| * @regulator_type: either REGULATOR_CURRENT or REGULATOR_VOLTAGE | |
| * @init_data: regulator_init_data | |
| * | |
| * This structure contains gpio-voltage regulator configuration | |
| * information that must be passed by platform code to the | |
| * gpio-voltage regulator driver. | |
| */ | |
| struct gpio_regulator_config { | |
| const char *supply_name; | |
| const char *input_supply; | |
| unsigned enabled_at_boot:1; | |
| unsigned startup_delay; | |
| enum gpiod_flags *gflags; | |
| int ngpios; | |
| struct gpio_regulator_state *states; | |
| int nr_states; | |
| enum regulator_type type; | |
| struct regulator_init_data *init_data; | |
| }; | |
| #endif |