| /* SPDX-License-Identifier: GPL-2.0+ WITH Linux-syscall-note */ | |
| /* | |
| * ipmi_smi.h | |
| * | |
| * MontaVista IPMI system management interface | |
| * | |
| * Author: MontaVista Software, Inc. | |
| * Corey Minyard <minyard@mvista.com> | |
| * source@mvista.com | |
| * | |
| * Copyright 2002 MontaVista Software Inc. | |
| * | |
| */ | |
| #ifndef __LINUX_IPMI_MSGDEFS_H | |
| #define __LINUX_IPMI_MSGDEFS_H | |
| /* Various definitions for IPMI messages used by almost everything in | |
| the IPMI stack. */ | |
| /* NetFNs and commands used inside the IPMI stack. */ | |
| #define IPMI_NETFN_SENSOR_EVENT_REQUEST 0x04 | |
| #define IPMI_NETFN_SENSOR_EVENT_RESPONSE 0x05 | |
| #define IPMI_GET_EVENT_RECEIVER_CMD 0x01 | |
| #define IPMI_NETFN_APP_REQUEST 0x06 | |
| #define IPMI_NETFN_APP_RESPONSE 0x07 | |
| #define IPMI_GET_DEVICE_ID_CMD 0x01 | |
| #define IPMI_COLD_RESET_CMD 0x02 | |
| #define IPMI_WARM_RESET_CMD 0x03 | |
| #define IPMI_CLEAR_MSG_FLAGS_CMD 0x30 | |
| #define IPMI_GET_DEVICE_GUID_CMD 0x08 | |
| #define IPMI_GET_MSG_FLAGS_CMD 0x31 | |
| #define IPMI_SEND_MSG_CMD 0x34 | |
| #define IPMI_GET_MSG_CMD 0x33 | |
| #define IPMI_SET_BMC_GLOBAL_ENABLES_CMD 0x2e | |
| #define IPMI_GET_BMC_GLOBAL_ENABLES_CMD 0x2f | |
| #define IPMI_READ_EVENT_MSG_BUFFER_CMD 0x35 | |
| #define IPMI_GET_CHANNEL_INFO_CMD 0x42 | |
| /* Bit for BMC global enables. */ | |
| #define IPMI_BMC_RCV_MSG_INTR 0x01 | |
| #define IPMI_BMC_EVT_MSG_INTR 0x02 | |
| #define IPMI_BMC_EVT_MSG_BUFF 0x04 | |
| #define IPMI_BMC_SYS_LOG 0x08 | |
| #define IPMI_NETFN_STORAGE_REQUEST 0x0a | |
| #define IPMI_NETFN_STORAGE_RESPONSE 0x0b | |
| #define IPMI_ADD_SEL_ENTRY_CMD 0x44 | |
| #define IPMI_NETFN_FIRMWARE_REQUEST 0x08 | |
| #define IPMI_NETFN_FIRMWARE_RESPONSE 0x09 | |
| /* The default slave address */ | |
| #define IPMI_BMC_SLAVE_ADDR 0x20 | |
| /* The BT interface on high-end HP systems supports up to 255 bytes in | |
| * one transfer. Its "virtual" BMC supports some commands that are longer | |
| * than 128 bytes. Use the full 256, plus NetFn/LUN, Cmd, cCode, plus | |
| * some overhead; it's not worth the effort to dynamically size this based | |
| * on the results of the "Get BT Capabilities" command. */ | |
| #define IPMI_MAX_MSG_LENGTH 272 /* multiple of 16 */ | |
| #define IPMI_CC_NO_ERROR 0x00 | |
| #define IPMI_NODE_BUSY_ERR 0xc0 | |
| #define IPMI_INVALID_COMMAND_ERR 0xc1 | |
| #define IPMI_TIMEOUT_ERR 0xc3 | |
| #define IPMI_ERR_MSG_TRUNCATED 0xc6 | |
| #define IPMI_REQ_LEN_INVALID_ERR 0xc7 | |
| #define IPMI_REQ_LEN_EXCEEDED_ERR 0xc8 | |
| #define IPMI_DEVICE_IN_FW_UPDATE_ERR 0xd1 | |
| #define IPMI_DEVICE_IN_INIT_ERR 0xd2 | |
| #define IPMI_NOT_IN_MY_STATE_ERR 0xd5 /* IPMI 2.0 */ | |
| #define IPMI_LOST_ARBITRATION_ERR 0x81 | |
| #define IPMI_BUS_ERR 0x82 | |
| #define IPMI_NAK_ON_WRITE_ERR 0x83 | |
| #define IPMI_ERR_UNSPECIFIED 0xff | |
| #define IPMI_CHANNEL_PROTOCOL_IPMB 1 | |
| #define IPMI_CHANNEL_PROTOCOL_ICMB 2 | |
| #define IPMI_CHANNEL_PROTOCOL_SMBUS 4 | |
| #define IPMI_CHANNEL_PROTOCOL_KCS 5 | |
| #define IPMI_CHANNEL_PROTOCOL_SMIC 6 | |
| #define IPMI_CHANNEL_PROTOCOL_BT10 7 | |
| #define IPMI_CHANNEL_PROTOCOL_BT15 8 | |
| #define IPMI_CHANNEL_PROTOCOL_TMODE 9 | |
| #define IPMI_CHANNEL_MEDIUM_IPMB 1 | |
| #define IPMI_CHANNEL_MEDIUM_ICMB10 2 | |
| #define IPMI_CHANNEL_MEDIUM_ICMB09 3 | |
| #define IPMI_CHANNEL_MEDIUM_8023LAN 4 | |
| #define IPMI_CHANNEL_MEDIUM_ASYNC 5 | |
| #define IPMI_CHANNEL_MEDIUM_OTHER_LAN 6 | |
| #define IPMI_CHANNEL_MEDIUM_PCI_SMBUS 7 | |
| #define IPMI_CHANNEL_MEDIUM_SMBUS1 8 | |
| #define IPMI_CHANNEL_MEDIUM_SMBUS2 9 | |
| #define IPMI_CHANNEL_MEDIUM_USB1 10 | |
| #define IPMI_CHANNEL_MEDIUM_USB2 11 | |
| #define IPMI_CHANNEL_MEDIUM_SYSINTF 12 | |
| #define IPMI_CHANNEL_MEDIUM_OEM_MIN 0x60 | |
| #define IPMI_CHANNEL_MEDIUM_OEM_MAX 0x7f | |
| #endif /* __LINUX_IPMI_MSGDEFS_H */ |