|  | // SPDX-License-Identifier: GPL-2.0 | 
|  | /* | 
|  | * Copyright (C) 2010 Google, Inc. | 
|  | * | 
|  | * This software is licensed under the terms of the GNU General Public | 
|  | * License version 2, as published by the Free Software Foundation, and | 
|  | * may be copied, distributed, and modified under those terms. | 
|  | * | 
|  | * This program is distributed in the hope that it will be useful, | 
|  | * but WITHOUT ANY WARRANTY; without even the implied warranty of | 
|  | * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the | 
|  | * GNU General Public License for more details. | 
|  | * | 
|  | */ | 
|  |  | 
|  | #ifndef __TEGRA_USB_PHY_H | 
|  | #define __TEGRA_USB_PHY_H | 
|  |  | 
|  | #include <linux/clk.h> | 
|  | #include <linux/gpio.h> | 
|  | #include <linux/reset.h> | 
|  | #include <linux/usb/otg.h> | 
|  |  | 
|  | /* | 
|  | * utmi_pll_config_in_car_module: true if the UTMI PLL configuration registers | 
|  | *     should be set up by clk-tegra, false if by the PHY code | 
|  | * has_hostpc: true if the USB controller has the HOSTPC extension, which | 
|  | *     changes the location of the PHCD and PTS fields | 
|  | * requires_usbmode_setup: true if the USBMODE register needs to be set to | 
|  | *      enter host mode | 
|  | * requires_extra_tuning_parameters: true if xcvr_hsslew, hssquelch_level | 
|  | *      and hsdiscon_level should be set for adequate signal quality | 
|  | */ | 
|  |  | 
|  | struct tegra_phy_soc_config { | 
|  | bool utmi_pll_config_in_car_module; | 
|  | bool has_hostpc; | 
|  | bool requires_usbmode_setup; | 
|  | bool requires_extra_tuning_parameters; | 
|  | }; | 
|  |  | 
|  | struct tegra_utmip_config { | 
|  | u8 hssync_start_delay; | 
|  | u8 elastic_limit; | 
|  | u8 idle_wait_delay; | 
|  | u8 term_range_adj; | 
|  | bool xcvr_setup_use_fuses; | 
|  | u8 xcvr_setup; | 
|  | u8 xcvr_lsfslew; | 
|  | u8 xcvr_lsrslew; | 
|  | u8 xcvr_hsslew; | 
|  | u8 hssquelch_level; | 
|  | u8 hsdiscon_level; | 
|  | }; | 
|  |  | 
|  | enum tegra_usb_phy_port_speed { | 
|  | TEGRA_USB_PHY_PORT_SPEED_FULL = 0, | 
|  | TEGRA_USB_PHY_PORT_SPEED_LOW, | 
|  | TEGRA_USB_PHY_PORT_SPEED_HIGH, | 
|  | }; | 
|  |  | 
|  | struct tegra_xtal_freq; | 
|  |  | 
|  | struct tegra_usb_phy { | 
|  | int instance; | 
|  | const struct tegra_xtal_freq *freq; | 
|  | void __iomem *regs; | 
|  | void __iomem *pad_regs; | 
|  | struct clk *clk; | 
|  | struct clk *pll_u; | 
|  | struct clk *pad_clk; | 
|  | struct regulator *vbus; | 
|  | enum usb_dr_mode mode; | 
|  | void *config; | 
|  | const struct tegra_phy_soc_config *soc_config; | 
|  | struct usb_phy *ulpi; | 
|  | struct usb_phy u_phy; | 
|  | bool is_legacy_phy; | 
|  | bool is_ulpi_phy; | 
|  | struct gpio_desc *reset_gpio; | 
|  | struct reset_control *pad_rst; | 
|  | bool powered_on; | 
|  | }; | 
|  |  | 
|  | void tegra_usb_phy_preresume(struct usb_phy *phy); | 
|  |  | 
|  | void tegra_usb_phy_postresume(struct usb_phy *phy); | 
|  |  | 
|  | void tegra_ehci_phy_restore_start(struct usb_phy *phy, | 
|  | enum tegra_usb_phy_port_speed port_speed); | 
|  |  | 
|  | void tegra_ehci_phy_restore_end(struct usb_phy *phy); | 
|  |  | 
|  | #endif /* __TEGRA_USB_PHY_H */ |