arch/arm/boot/dts/ste-href-tvk1281618-r3.dtsi

// SPDX-License-Identifier: GPL-2.0-or-later
/*
 * Device Tree for the TVK1281618 R2 UIB
 */

#include "ste-href-tvk1281618.dtsi"

/ {
	soc {
		i2c@80128000 {
			accelerometer@19 {
				compatible = "st,lsm303dlhc-accel";
				st,drdy-int-pin = <1>;
				reg = <0x19>;
				vdd-supply = <&ab8500_ldo_aux1_reg>;
				vddio-supply = <&db8500_vsmps2_reg>;
				interrupt-parent = <&gpio2>;
				interrupts = <18 IRQ_TYPE_EDGE_RISING>,
					     <19 IRQ_TYPE_EDGE_RISING>;
				pinctrl-names = "default";
				pinctrl-0 = <&accel_tvk_mode>;
				mount-matrix = "0", "-1", "0",
					       "-1", "0", "0",
					       "0", "0", "-1";
			};
			magnetometer@1e {
				compatible = "st,lsm303dlm-magn";
				st,drdy-int-pin = <1>;
				reg = <0x1e>;
				vdd-supply = <&ab8500_ldo_aux1_reg>;
				vddio-supply = <&db8500_vsmps2_reg>;
				// This interrupt is not properly working with the driver
				// interrupt-parent = <&gpio1>;
				// interrupts = <0 IRQ_TYPE_EDGE_RISING>;
				pinctrl-names = "default";
				pinctrl-0 = <&magn_tvk_mode>;
			};
			gyroscope@68 {
				/* Gyroscope */
				compatible = "st,l3g4200d-gyro";
				reg = <0x68>;
				vdd-supply = <&ab8500_ldo_aux1_reg>;
				vddio-supply = <&db8500_vsmps2_reg>;
			};
			pressure@5c {
				/* Barometer/pressure sensor */
				compatible = "st,lps001wp-press";
				reg = <0x5c>;
				vdd-supply = <&ab8500_ldo_aux1_reg>;
				vddio-supply = <&db8500_vsmps2_reg>;
			};
		};

		mcde@a0350000 {
			status = "okay";

			dsi-controller@a0351000 {
				panel {
					compatible = "sony,acx424akp";
					reg = <0>;
					vddi-supply = <&ab8500_ldo_aux1_reg>;
					reset-gpios = <&gpio2 1 GPIO_ACTIVE_LOW>;
				};
			};
		};

		pinctrl {
			accelerometer {
				accel_tvk_mode: accel_tvk {
					/* Accelerometer interrupt lines 1 & 2 */
					tvk_cfg {
						pins = "GPIO82_C1", "GPIO83_D3";
						ste,config = <&gpio_in_pd>;
					};
				};
			};
			magnetometer {
				magn_tvk_mode: magn_tvk {
					/* GPIO 32 used for DRDY, pull this down */
					tvk_cfg {
						pins = "GPIO32_V2";
						ste,config = <&gpio_in_pd>;
					};
				};
			};
		};
	};
};