blob: eae1c8ddc9f949736eff3ce6432ed497d2e49b72 [file] [log] [blame]
config FIRMWARE
bool "Enable Firmware driver support"
config SPL_FIRMWARE
bool "Enable Firmware driver support in SPL"
depends on FIRMWARE && SPL
config SPL_ARM_PSCI_FW
bool
select SPL_FIRMWARE
config ARM_PSCI_FW
bool
select FIRMWARE
config TI_SCI_PROTOCOL
tristate "TI System Control Interface (TISCI) Message Protocol"
depends on K3_SEC_PROXY
select FIRMWARE
select SPL_FIRMWARE if SPL
help
TI System Control Interface (TISCI) Message Protocol is used to manage
compute systems such as ARM, DSP etc with the system controller in
complex System on Chip (SoC) such as those found on certain K3
generation SoC from TI.
This protocol library is used by client drivers to use the features
provided by the system controller.
config ZYNQMP_FIRMWARE
bool "ZynqMP Firmware interface"
select FIRMWARE
help
Firmware interface driver is used by different
drivers to communicate with the firmware for
various platform management services.
Say yes to enable ZynqMP firmware interface driver.
If in doubt, say N.
config ARM_SMCCC_FEATURES
bool "Arm SMCCC features discovery"
depends on ARM_PSCI_FW
help
Discover Arm SMCCC features for which a U-Boot driver is defined. When enabled,
the PSCI driver is always probed and binds dirvers registered to the Arm SMCCC
services if any and reported as supported by the SMCCC firmware.
source "drivers/firmware/scmi/Kconfig"