| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <ec/google/wilco/romstage.h> |
| #include <soc/cnl_memcfg_init.h> |
| #include <soc/romstage.h> |
| #include <variant/gpio.h> |
| |
| static const struct cnl_mb_cfg memcfg = { |
| /* Access memory info through SMBUS. */ |
| .spd[0] = { |
| .read_type = READ_SMBUS, |
| .spd_spec = {.spd_smbus_address = 0xa0}, |
| }, |
| .spd[1] = {.read_type = NOT_EXISTING}, |
| .spd[2] = { |
| .read_type = READ_SMBUS, |
| .spd_spec = {.spd_smbus_address = 0xa4}, |
| }, |
| .spd[3] = {.read_type = NOT_EXISTING}, |
| |
| /* |
| * The dqs_map arrays map the ddr4 pins to the SoC pins |
| * for both channels. |
| * |
| * the index = pin number on ddr4 part |
| * the value = pin number on SoC |
| */ |
| .dqs_map[DDR_CH0] = {0, 1, 4, 5, 2, 3, 6, 7}, |
| .dqs_map[DDR_CH1] = {0, 1, 4, 5, 2, 3, 6, 7}, |
| |
| /* Baseboard uses 121, 81 and 100 rcomp resistors */ |
| .rcomp_resistor = {121, 81, 100}, |
| |
| /* |
| * Baseboard Rcomp target values. |
| */ |
| .rcomp_targets = {100, 40, 20, 20, 26}, |
| |
| /* Disable Early Command Training */ |
| .ect = 0, |
| |
| /* Base on board design */ |
| .vref_ca_config = 2, |
| }; |
| |
| void mainboard_memory_init_params(FSPM_UPD *memupd) |
| { |
| const struct pad_config *pads; |
| size_t pads_num; |
| |
| wilco_ec_romstage_init(); |
| |
| cannonlake_memcfg_init(&memupd->FspmConfig, &memcfg); |
| |
| pads = variant_romstage_gpio_table(&pads_num); |
| gpio_configure_pads(pads, pads_num); |
| } |