| /* SPDX-License-Identifier: GPL-2.0-only */ |
| |
| #include <bootmode.h> |
| #include <device/device.h> |
| #include <soc/bl31.h> |
| #include <soc/i2c.h> |
| #include <soc/msdc.h> |
| #include <soc/mt6359p.h> |
| #include <soc/mtcmos.h> |
| #include <soc/usb.h> |
| |
| #include "display.h" |
| #include "gpio.h" |
| |
| #define AFE_SE_SECURE_CON (AUDIO_BASE + 0x17a8) |
| |
| static void configure_i2s(void) |
| { |
| /* Audio PWR */ |
| mtcmos_audio_power_on(); |
| mtcmos_protect_audio_bus(); |
| |
| /* Switch to normal mode */ |
| write32p(AFE_SE_SECURE_CON, 0x0); |
| |
| /* SoC I2S */ |
| gpio_set_mode(GPIO_I2SI1_LRCK, PAD_I2SO2_D2_FUNC_TDMIN_LRCK); |
| gpio_set_mode(GPIO_I2SI1_BCK, PAD_I2SIN_D3_FUNC_TDMIN_BCK); |
| gpio_set_mode(GPIO_I2SO1_D0, PAD_GPIO11_FUNC_I2SO1_D0); |
| } |
| |
| static void configure_audio(void) |
| { |
| if (CONFIG(USE_MAX98390)) { |
| printk(BIOS_DEBUG, "Configure MAX98390 audio\n"); |
| |
| mtk_i2c_bus_init(I2C0, I2C_SPEED_FAST); |
| configure_i2s(); |
| } |
| } |
| |
| static void mainboard_init(struct device *dev) |
| { |
| mt6359p_init_pmif_arb(); |
| |
| if (display_init_required()) { |
| if (configure_display() < 0) |
| printk(BIOS_ERR, "%s: Failed to init display\n", __func__); |
| } else { |
| printk(BIOS_INFO, "%s: Skipped display initialization\n", __func__); |
| } |
| |
| mtk_msdc_configure_emmc(true); |
| |
| configure_audio(); |
| |
| if (CONFIG(SDCARD_INIT)) |
| mtk_msdc_configure_sdcard(); |
| |
| setup_usb_host(); |
| |
| if (CONFIG(ARM64_USE_ARM_TRUSTED_FIRMWARE)) |
| register_reset_to_bl31(GPIO_AP_EC_WARM_RST_REQ.id, true); |
| } |
| |
| static void mainboard_enable(struct device *dev) |
| { |
| dev->ops->init = &mainboard_init; |
| } |
| |
| struct chip_operations mainboard_ops = { |
| .enable_dev = mainboard_enable, |
| }; |