| # Config file for /etc/init.d/ser2net |
| |
| # Set the configuration file to one other than the default of /etc/ser2net.conf |
| # |
| #CONFIG_FILE="/etc/ser2net.conf" |
| |
| # Enables the control port and sets the TCP port to listen to for the control port. |
| # A port number may be of the form [host,]port, such as 127.0.0.1,2000 or localhost,2000. |
| # If this is specified, it will only bind to the IP address specified for the port. |
| # Otherwise, it will bind to all the addresses on the machine. |
| # |
| #CONTROL_PORT="" |
| |
| # Cisco IOS uses a different mechanism for specifying the baud rates than the mechanism |
| # described in RFC2217. This option sets the IOS version of setting the baud rates. |
| # The default is RFC2217s. |
| # |
| #CISCO_IOS="yes" |
| |
| # Enable or disable UUCP locking (default=yes) |
| # |
| #UUCP_LOCKS="no" |
| |
| # see the ser2net(8) manual page for additional options you can configure here |
| # |
| #EXTRA_OPTS="" |
| |