ARM: OMAP2+: Remove legacy mux code
All the boards booting with device tree use
drivers/pinctrl-single.c instead.
Note that mach-omap1 is still using the legacy mux,
so let's move the related Kconfig options from plat-omap
to mach-omap1.
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap1/Kconfig b/arch/arm/mach-omap1/Kconfig
index afb80950..45c6b73 100644
--- a/arch/arm/mach-omap1/Kconfig
+++ b/arch/arm/mach-omap1/Kconfig
@@ -31,6 +31,32 @@
select ARCH_OMAP_OTG
select CPU_ARM926T
+config OMAP_MUX
+ bool "OMAP multiplexing support"
+ depends on ARCH_OMAP
+ default y
+ help
+ Pin multiplexing support for OMAP boards. If your bootloader
+ sets the multiplexing correctly, say N. Otherwise, or if unsure,
+ say Y.
+
+config OMAP_MUX_DEBUG
+ bool "Multiplexing debug output"
+ depends on OMAP_MUX
+ help
+ Makes the multiplexing functions print out a lot of debug info.
+ This is useful if you want to find out the correct values of the
+ multiplexing registers.
+
+config OMAP_MUX_WARNINGS
+ bool "Warn about pins the bootloader didn't set up"
+ depends on OMAP_MUX
+ default y
+ help
+ Choose Y here to warn whenever driver initialization logic needs
+ to change the pin multiplexing setup. When there are no warnings
+ printed, it's safe to deselect OMAP_MUX for your product.
+
comment "OMAP Board Type"
depends on ARCH_OMAP1
