| /* SPDX-License-Identifier: GPL-2.0+ WITH Linux-syscall-note */ |
| /* |
| * ipmi_smi.h |
| * |
| * MontaVista IPMI system management interface |
| * |
| * Author: MontaVista Software, Inc. |
| * Corey Minyard <minyard@mvista.com> |
| * source@mvista.com |
| * |
| * Copyright 2002 MontaVista Software Inc. |
| * |
| */ |
| |
| #ifndef __LINUX_IPMI_MSGDEFS_H |
| #define __LINUX_IPMI_MSGDEFS_H |
| |
| /* Various definitions for IPMI messages used by almost everything in |
| the IPMI stack. */ |
| |
| /* NetFNs and commands used inside the IPMI stack. */ |
| |
| #define IPMI_NETFN_SENSOR_EVENT_REQUEST 0x04 |
| #define IPMI_NETFN_SENSOR_EVENT_RESPONSE 0x05 |
| #define IPMI_GET_EVENT_RECEIVER_CMD 0x01 |
| |
| #define IPMI_NETFN_APP_REQUEST 0x06 |
| #define IPMI_NETFN_APP_RESPONSE 0x07 |
| #define IPMI_GET_DEVICE_ID_CMD 0x01 |
| #define IPMI_COLD_RESET_CMD 0x02 |
| #define IPMI_WARM_RESET_CMD 0x03 |
| #define IPMI_CLEAR_MSG_FLAGS_CMD 0x30 |
| #define IPMI_GET_DEVICE_GUID_CMD 0x08 |
| #define IPMI_GET_MSG_FLAGS_CMD 0x31 |
| #define IPMI_SEND_MSG_CMD 0x34 |
| #define IPMI_GET_MSG_CMD 0x33 |
| #define IPMI_SET_BMC_GLOBAL_ENABLES_CMD 0x2e |
| #define IPMI_GET_BMC_GLOBAL_ENABLES_CMD 0x2f |
| #define IPMI_READ_EVENT_MSG_BUFFER_CMD 0x35 |
| #define IPMI_GET_CHANNEL_INFO_CMD 0x42 |
| |
| /* Bit for BMC global enables. */ |
| #define IPMI_BMC_RCV_MSG_INTR 0x01 |
| #define IPMI_BMC_EVT_MSG_INTR 0x02 |
| #define IPMI_BMC_EVT_MSG_BUFF 0x04 |
| #define IPMI_BMC_SYS_LOG 0x08 |
| |
| #define IPMI_NETFN_STORAGE_REQUEST 0x0a |
| #define IPMI_NETFN_STORAGE_RESPONSE 0x0b |
| #define IPMI_ADD_SEL_ENTRY_CMD 0x44 |
| |
| #define IPMI_NETFN_FIRMWARE_REQUEST 0x08 |
| #define IPMI_NETFN_FIRMWARE_RESPONSE 0x09 |
| |
| /* The default slave address */ |
| #define IPMI_BMC_SLAVE_ADDR 0x20 |
| |
| /* The BT interface on high-end HP systems supports up to 255 bytes in |
| * one transfer. Its "virtual" BMC supports some commands that are longer |
| * than 128 bytes. Use the full 256, plus NetFn/LUN, Cmd, cCode, plus |
| * some overhead; it's not worth the effort to dynamically size this based |
| * on the results of the "Get BT Capabilities" command. */ |
| #define IPMI_MAX_MSG_LENGTH 272 /* multiple of 16 */ |
| |
| #define IPMI_CC_NO_ERROR 0x00 |
| #define IPMI_NODE_BUSY_ERR 0xc0 |
| #define IPMI_INVALID_COMMAND_ERR 0xc1 |
| #define IPMI_TIMEOUT_ERR 0xc3 |
| #define IPMI_ERR_MSG_TRUNCATED 0xc6 |
| #define IPMI_REQ_LEN_INVALID_ERR 0xc7 |
| #define IPMI_REQ_LEN_EXCEEDED_ERR 0xc8 |
| #define IPMI_DEVICE_IN_FW_UPDATE_ERR 0xd1 |
| #define IPMI_DEVICE_IN_INIT_ERR 0xd2 |
| #define IPMI_NOT_IN_MY_STATE_ERR 0xd5 /* IPMI 2.0 */ |
| #define IPMI_LOST_ARBITRATION_ERR 0x81 |
| #define IPMI_BUS_ERR 0x82 |
| #define IPMI_NAK_ON_WRITE_ERR 0x83 |
| #define IPMI_ERR_UNSPECIFIED 0xff |
| |
| #define IPMI_CHANNEL_PROTOCOL_IPMB 1 |
| #define IPMI_CHANNEL_PROTOCOL_ICMB 2 |
| #define IPMI_CHANNEL_PROTOCOL_SMBUS 4 |
| #define IPMI_CHANNEL_PROTOCOL_KCS 5 |
| #define IPMI_CHANNEL_PROTOCOL_SMIC 6 |
| #define IPMI_CHANNEL_PROTOCOL_BT10 7 |
| #define IPMI_CHANNEL_PROTOCOL_BT15 8 |
| #define IPMI_CHANNEL_PROTOCOL_TMODE 9 |
| |
| #define IPMI_CHANNEL_MEDIUM_IPMB 1 |
| #define IPMI_CHANNEL_MEDIUM_ICMB10 2 |
| #define IPMI_CHANNEL_MEDIUM_ICMB09 3 |
| #define IPMI_CHANNEL_MEDIUM_8023LAN 4 |
| #define IPMI_CHANNEL_MEDIUM_ASYNC 5 |
| #define IPMI_CHANNEL_MEDIUM_OTHER_LAN 6 |
| #define IPMI_CHANNEL_MEDIUM_PCI_SMBUS 7 |
| #define IPMI_CHANNEL_MEDIUM_SMBUS1 8 |
| #define IPMI_CHANNEL_MEDIUM_SMBUS2 9 |
| #define IPMI_CHANNEL_MEDIUM_USB1 10 |
| #define IPMI_CHANNEL_MEDIUM_USB2 11 |
| #define IPMI_CHANNEL_MEDIUM_SYSINTF 12 |
| #define IPMI_CHANNEL_MEDIUM_OEM_MIN 0x60 |
| #define IPMI_CHANNEL_MEDIUM_OEM_MAX 0x7f |
| |
| #endif /* __LINUX_IPMI_MSGDEFS_H */ |