gru: Add USB 2.0 PHY tuning for Kevin PHY0 and PHY1
We found that Kevin board PHY0 and PHY1 eye-diagram margin
is not enough to make compliance test pass, and the PHY0 USB
SI is worse than PHY1, because of the higher PCB impedance.
For PHY0, we can't improve the eye-diagram by SW PHY tuning,
so we need to reduce the RBIAS resistance from 133 ohm to 115
ohm, it can help to increase the eye-height.
For PHY1, we can improve the eye-diagram by setting the max
pre-emphasis level.
And after the above change, the USB2 signal amplitude will
become larger at the test point near to SOC USB2 PHY, in order
to avoid mis-trigger the disconnect detection (650mV), we need
to disable pre-emphasize in eop state.
BRANCH=None
BUG=chrome-os-partner:53863
TEST=do USB 2.0 compliance test for Kevin C0 and C1 port.
Change-Id: I00cb325b9938e4276cc77b5d6f5faa7023379608
Signed-off-by: William wu <wulf@rock-chips.com>
Reviewed-on: https://chromium-review.googlesource.com/390615
Commit-Ready: Julius Werner <jwerner@chromium.org>
Tested-by: Julius Werner <jwerner@chromium.org>
Reviewed-by: Julius Werner <jwerner@chromium.org>
1 file changed
