Lenovo Ivy Bridge series

Flashing coreboot

+---------------------+--------------------------------+
| Type                | Value                          |
+=====================+================================+
| Socketed flash      | no                             |
+---------------------+--------------------------------+
| Size                | 8 MiB + 4MiB                   |
+---------------------+--------------------------------+
| In circuit flashing | Yes                            |
+---------------------+--------------------------------+
| Package             | SOIC-8                         |
+---------------------+--------------------------------+
| Write protection    | No                             |
+---------------------+--------------------------------+
| Dual BIOS feature   | No                             |
+---------------------+--------------------------------+
| Internal flashing   | Yes                            |
+---------------------+--------------------------------+

Installation instructions

  • Update the EC firmware, as there's no support for EC updates in coreboot.
  • Do NOT accidently swap pins or power on the board while a SPI flasher is connected. It will permanently brick your device.
  • It‘s recommended to only flash the BIOS region. In that case you don’t need to extract blobs from vendor firmware. If you want to flash the whole chip, you need blobs when building coreboot.
  • The Flash layout shows that by default 7MiB of space are available for the use with coreboot.
  • In that case you only want to use a part of the BIOS region that must not exceed 4MiB in size, which means CONFIG_CBFS_SIZE must be smaller than 4MiB.
  • ROM chip size should be set to 12MiB.
Please also have a look at :doc:`../../flash_tutorial/index`.

Splitting the coreboot.rom

To split the coreboot.rom into two images (one for the 8MiB and one for the 4 MiB flash IC), run the following commands:

dd of=top.rom bs=1M if=build/coreboot.rom skip=8
dd of=bottom.rom bs=1M if=build/coreboot.rom count=8

That gives one ROM for each flash IC, where top.rom is the upper part of the flash image, that resides on the 4 MiB flash and bottom.rom is the lower part of the flash image, that resides on the 8 MiB flash.

Dumping a full ROM

If you flash externally you need to read both flash chips to get two images (one for the 8MiB and one for the 4 MiB flash IC), and then run the following command to concatenate the files:

cat bottom.rom top.rom > firmware.rom

Flash layout

There‘s one 8MiB and one 4 MiB flash which contains IFD, GBE, ME and BIOS region. These two flash ICs appear as a single 12MiB when flashing internally. On Lenovo’s UEFI the EC firmware update is placed at the start of the BIOS region. The update is then written into the EC once.