| /* TODO: This is currently copied from the IEI NOVA-4899R target, but it's |
| * quite surely wrong for this board. It gets me further in the boot process |
| * than using no irq_tables.c file at all, though! |
| */ |
| |
| /* TODO: Add license header. */ |
| |
| #include <arch/pirq_routing.h> |
| |
| static const struct irq_routing_table intel_irq_routing_table = { |
| PIRQ_SIGNATURE, /* u32 signature */ |
| PIRQ_VERSION, /* u16 version */ |
| 32+16*CONFIG_IRQ_SLOT_COUNT, /* there can be total CONFIG_IRQ_SLOT_COUNT devices on the bus */ |
| 0x00, /* Where the interrupt router lies (bus) */ |
| (0x12<<3)|0x0, /* Where the interrupt router lies (dev) */ |
| 0xe00, /* IRQs devoted exclusively to PCI usage */ |
| 0x1078, /* Vendor */ |
| 0x0002, /* Device */ |
| 0, /* Miniport data */ |
| { 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0 }, /* u8 rfu[11] */ |
| 0x2d, /* u8 checksum , this hase to set to some value that would give 0 after the sum of all bytes for this structure (including checksum) */ |
| { |
| /* bus, dev|fn, {link, bitmap}, {link, bitmap}, {link, bitmap}, {link, bitmap}, slot, rfu */ |
| // USB |
| {0x00,(0x13<<3)|0x0, {{0x01, 0xdeb8}, {0x00, 0xdeb8}, {0x00, 0xdeb8}, {0x00, 0x0deb8}}, 0x0, 0x0}, |
| // eth0 |
| {0x00,(0x0a<<3)|0x0, {{0x02, 0xdeb8}, {0x03, 0xdeb8}, {0x04, 0xdeb8}, {0x00, 0x0deb8}}, 0x0, 0x0},//0x3, 0x0}, |
| // eth1 |
| {0x00,(0x0b<<3)|0x0, {{0x03, 0xdeb8}, {0x04, 0xdeb8}, {0x02, 0xdeb8}, {0x00, 0x0deb8}}, 0x0, 0x0},//0x2, 0x0}, |
| // eth2 |
| {0x00,(0x0c<<3)|0x0, {{0x04, 0xdeb8}, {0x02, 0xdeb8}, {0x03, 0xdeb8}, {0x00, 0x0deb8}}, 0x0, 0x0},//0x1, 0x0}, |
| // PCI slot |
| {0x00,(0x0f<<3)|0x0, {{0x04, 0xdeb8}, {0x03, 0xdeb8}, {0x02, 0xdeb8}, {0x00, 0x0deb8}}, 0x0, 0x0}, |
| } |
| }; |
| unsigned long write_pirq_routing_table(unsigned long addr) |
| { |
| return copy_pirq_routing_table(addr, &intel_irq_routing_table); |
| } |
