| if BOARD_LIPPERT_HURRICANE_LX |
| |
| config BOARD_SPECIFIC_OPTIONS # dummy |
| def_bool y |
| select ARCH_X86 |
| select CPU_AMD_GEODE_LX |
| select NORTHBRIDGE_AMD_LX |
| select SOUTHBRIDGE_AMD_CS5536 |
| select SUPERIO_ITE_IT8712F |
| select HAVE_PIRQ_TABLE |
| select PIRQ_ROUTE |
| select UDELAY_TSC |
| # Board is equipped with a 1 MB SPI flash, however, due to limitations |
| # of the IT8712F Super I/O, only the top 512 KB are directly mapped. |
| select BOARD_ROMSIZE_KB_512 |
| select PLL_MANUAL_CONFIG |
| select CORE_GLIU_500_333 |
| |
| config MAINBOARD_DIR |
| string |
| default lippert/hurricane-lx |
| |
| config MAINBOARD_PART_NUMBER |
| string |
| default "Hurricane-LX" |
| |
| config IRQ_SLOT_COUNT |
| int |
| default 8 |
| |
| config BOARD_OLD_REVISION |
| bool "Board is old pre-3.0 revision" |
| default n |
| select POWER_BUTTON_DEFAULT_DISABLE |
| help |
| Look on the bottom side for a number like 406-0001-30. The last 2 |
| digits state the PCB revision (3.0 in this example). For 2.0 or older |
| boards choose Y, for 3.0 and newer say N. |
| |
| Old revision boards need a jumper shorting the power button to |
| power on automatically. You may enable the button only after this |
| jumper has been removed. New revision boards are not restricted |
| in this way, and always have the power button enabled. |
| |
| config POWER_BUTTON_FORCE_ENABLE |
| def_bool y if !BOARD_OLD_REVISION |
| |
| config ONBOARD_UARTS_RS485 |
| bool "Switch on-board serial ports to RS485" |
| default n |
| help |
| If selected, both on-board serial ports will operate in RS485 mode |
| instead of RS232. |
| |
| config PLLMSRlo |
| hex |
| default 0x00de6001 |
| |
| endif # BOARD_LIPPERT_HURRICANE_LX |
